Nonlinear vibration response of a complex aeroengine under the rubbing fault

Nonlinear Dynamics - Rolling bearing and squeeze film damper will introduce structural nonlinearity into the dynamic model of aeroengine. Rubbing will occur due to the clearance reduction design of...     

硅和锗纳米线的原子排布和电荷分布的密度泛函紧束缚方法研究

低维硅锗材料是制备纳米电子器件的重要候选材料，是研发高效率、低能耗和超高速新一代纳米电子器件的基础材料之一，有着潜在的应用价值。采用密度泛函紧束缚方法分别对厚度相同、宽度在0.272 nm~0.554 nm之间的硅纳米线和宽度在0.283 nm~0.567 nm之间的锗纳米线的原子排布和电荷分布进行了计算研究。硅、锗纳米线宽度的改变使原子排布，纳米线的原子间键长和键角发生明显改变。纳米线表层结构的改变对各层内的电荷分布产生重要影响。纳米线中各原子的电荷转移量与该原子在表层内的位置相关。纳米线的尺寸和表层内原子排列结构对体系的稳定性产生重要影响。     

A Note on Quantum Bell Nonlocality and Quantum Entanglement for High Dimensional Quantum Systems

We study the Bell nonlocality of high dimensional quantum systems based on quantum entanglement. A quantitative relationship between the maximal expectation value B of Bell operators and the quantum entanglement concurrence C is obtained for even dimension pure states, with the upper and lower bounds of B governed by C.

     

Na原子链表面等离激元特性的含时密度泛函研究

本文用含时密度泛函理论研究了线性Na原子链的表面等离激元机理.主要在原子尺度下模拟计算了体系随着原子数增加及原子间距变化的集体激发过程.研究发现线性原子链有一个普遍的特性——存在一个纵模和两个横模.两个横模一般在实验上很难被观测到.纵模随着原子链长度增加,能量红移的同时,该纵模主峰的强度呈线性增长.随着原子个数的增加,端点模式(TE)开始蓝移,能量和偶极强度都逐渐趋向饱和.横模能量被劈裂的原因概括如下:(一)每个位置的电子受到的势不同,在两端的电子受到的势要比在中间的电子受到的势要高,因此两端的电荷积累也比中间多;(二)端点存在悬挂键,所以中间的电子-电子间相互作用与端点的不一样,这两方面又都与原子间距d有关.     

氨基功能化磁性CoFe2O4/氧化石墨烯去除电镀废水中Cr(Ⅵ)的研究

使用改良的hummers法制备出的氧化石墨烯为载体,采用共沉淀法制备出磁性CoFe2O4/氧化石墨烯(MGO),再使用三乙烯四胺(TETA)对磁性CoFe2O4/氧化石墨烯进行氨基功能化,制备出氨基功能化磁性CoFe2O4/氧化石墨烯吸附剂.采用X-射线衍射仪(XRD)、傅里叶变换红外光谱仪(FT-IR)和扫描电子显微镜(SEM)对TETA-MGO的物相、化学组成和微观形貌进行表征,以TETA-MGO作为吸附剂去除电镀废水中Cr(Ⅵ),探讨吸附性能和吸附机理,分析TETA-MGO在外加磁场下的液固分离和再生吸附性能.结果表明纳米级立方尖晶石相磁性CoFe2O4均匀生长于氧化石墨烯的表面和片层之间,TETA通过C-N键与磁性氧化石墨烯(MGO)相连,氨基功能化成功,活性吸附位点增点.室温下,pH =2时吸附效果最佳,吸附120 min时达到吸附平衡,平衡吸附量约为48.66 mg·g-1,TETA-MGO对Cr(Ⅵ)的吸附动力学和吸附热力学可分别使用拟二级动力学模型和Langmuir等温吸附模型描述,吸附过程主要属于化学吸附控制的单分子层吸附,使用外加磁场可以对TETA-MGO实现简单的固液分离,TETA-MGO经过6次再生吸附后,对Cr(Ⅵ)的吸附量仅下降19.67;,说明具有良好的循环再生吸附能力.     

Bi-2223/Ag异质结的光生电压效应研究

在50 ～ 340 K不同温度下,利用紫色激光(λ=405 nm)对银/铋锶钙铜氧2223异质结界面进行辐照,观测到明显的光生电压效应,发现光生电压的极性分别在超导转变温度TC与320 K附近发生了反转,排除了激光产生的热电势是产生光生电压的原因,分析表明银/铋锶钙铜氧2223异质结界面处存在内建电场:光生电压由异质结界面处的内建电场分离光生电子-空穴对产生的.超导转变温度TC之下以及320 K以上,内建电场方向从超导体指向金属电极;超导转变温度TC与反向温度320 K之间,内建电场从金属指向超导体.     

零维到三维结构中三核铜自旋阻挫簇单元的磁构关系和反对称交换

量子自旋液体是最近几年刚被人们证实除铁磁体、反铁磁体之外的第三种磁性类型,因其有望解释高温超导的运行机制、改变计算机硬盘信息存储方式而在物理、材料等领域备受关注。自旋阻挫作为量子自旋液体的最小单元可能是解开量子自旋液体诸多问题的钥匙,所以在磁学、电学研究领域再一次成为人们研究的热点。基于文献报道的三核铜配合物[Cu3(μ3-OH)(μ-OPz)3(NO3)2(H2O)2]·CH3OH(1),我们合成了三维金属有机框架配合物{[Ag(HOPz)Cu3(μ3-OH)(NO3)3(OPz)2Ag(NO3)]·6H2O}n(2)(HOPz=甲基(2-吡嗪基)酮肟),并从自旋阻挫的角度对二者磁性质进行对比和详细分析。磁化率数据表明自旋间有很强的反铁磁相互作用和反对称交换。通过包含各向同性和反对称交换的哈密顿算符对两者磁学数据进行拟合并研究其磁构关系,所获最佳拟合参数为:配合物1:Jav=-426 cm^-1,g⊥=1.83,g∥=2.00;配合物2:Jav=-401 cm^-1,g⊥=1.85,g∥=2.00。     

Characteristics of black carbon aerosol in Jiaxing,China during autumn 2013

We conducted measurements of black carbon（BC） aerosol in Jiaxing,China during autumn from September 26 to November 30,2013.We investigated temporal and diurnal variations of BC,and its correlations with meteorological parameters and other major pollutants.Results showed that hourly mass concentrations of BC ranged from 0.2 to 22.0 μg/m³,with an average of 5.1 μg/m³.The diurnai variation of BC exhibited a bimodal distribution,with peaks at 07:00 and 18:00.The morning peak was larger than the evening peak.The mass percentages of BC in PM_2.5 and PM₁₀ were 7.1%and 4.8%,respectively.The absorption coefficient of BC was calculated to be 44.4 Mm^-1,which accounted for 11.1%of the total aerosol extinction.BC was mainly emitted from local sources in southwestern Jiaxing where BC concentrations were generally greater than 11 μg/m³ during the measurement period.Correlation analysis indicated that the main sources of BC were motor vehicle exhaust,and domestic and industrial combustion.     

Feasibility study on buoyancy–weight ratios of a submerged floating tunnel prototype subjected to hydrodynamic loads

The research progress of a novel traffic solution,a submerged floating tunnel(SFT),is reviewed in terms of a study approach and loading scenario.Among existing publications,the buoyancy-weight ratio(BWR) is usually predefined.However,BWR is a critical structural parameter that tremendously affects the dynamic behaviour of not only the tunnel tube itself but also the cable system.In the context of a SFT prototype(SFTP) project in Qiandao Lake(Zhejiang Province,China),the importance of BWR is illustrated by finite element analysis and subsequently,an optimized BWR is proposed within a reasonable range in the present study.In the numerical model,structural damping is identified to be of importance.Rayleigh damping and the corresponding Rayleigh coefficients are attained through a sensitivity study,which shows that the adopted damping ratios are fairly suitable for SFTP.Lastly,the human sense of security is considered by quantifying the comfort index,which helps further optimize BWR in the SFTP structural parameter design.